otto机器人最后代码部分上传错误

Nero_Cheng

Arduino:1.8.10 Hourly Build 2019/05/07 05:33 (Windows 10), 开发板："Arduino Nano, ATmega328P"

项目使用了 11308 字节，占用了 (36%) 程序存储空间。最大为 30720 字节。
全局变量使用了828字节，(40%)的动态内存，余留1220字节局部变量。最大为2048字节。
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x7d
上传出错。查看http://www.arduino.cc/en/Guide/Troubleshooting#upload 获取建议。
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x7d
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x7d

编译通过然而上传出错，请问这是怎么回事？？？

Nero_Cheng

问题已解决，麻烦各位了。。。

wz2604467703

Nero_Cheng 发表于 2019-5-11 17:19
问题已解决，麻烦各位了。。。

你好   方便说一下问题原因吗？  因为我也有这样的错  现在不知道该怎么办