Arduino:1.8.19 (Windows 7), 开发板："Generic ESP8266 Module, 80 MHz, Flash, Legacy (new can return nullptr), All SSL ciphers (most compatible), dtr (aka nodemcu), 26 MHz, 40MHz, DOUT (compatible), 4MB (FS:1MB OTA:~1019KB), 2, nonos-sdk 2.2.1+100 (190703), v2 Lower Memory, Disabled, None, Only Sketch, 115200"
[SPIFFS] data : D:\2345Downloads\新建文件夹\Web配网，配秘钥\webconfig\esp8266-data-upload\data
[SPIFFS] size : 1000
[SPIFFS] page : 256
[SPIFFS] block : 8192
[SPIFFS] upload : C:\Users\ADMINI~1\AppData\Local\Temp\arduino_build_773564/esp8266-data-upload.spiffs.bin
[SPIFFS] address : 0x300000
[SPIFFS] reset : --before default_reset --after hard_reset
[SPIFFS] port : COM5
[SPIFFS] speed : 115200
[SPIFFS] python : C:\Users\Administrator\AppData\Local\Arduino15\packages\esp8266\tools\python3\3.7.2-post1\python3.exe
[SPIFFS] uploader : C:\Users\Administrator\AppData\Local\Arduino15\packages\esp8266\hardware\esp8266\2.7.4\tools\upload.py
esptool.py v2.8
Serial port COM5
Connecting....
Chip is ESP8266EX
Features: WiFi
Crystal is 26MHz
MAC: 94:b9:7e:13:f1:98
Uploading stub...
Running stub...
Stub running...
Configuring flash size...
Auto-detected Flash size: 1MB
Traceback (most recent call last):
File "C:\Users\Administrator\AppData\Local\Arduino15\packages\esp8266\hardware\esp8266\2.7.4\tools\upload.py", line 65, in <module>
esptool.main(cmdline)
File "C:/Users/Administrator/AppData/Local/Arduino15/packages/esp8266/hardware/esp8266/2.7.4/tools/esptool\esptool.py", line 2938, in main
operation_func(esp, args)
File "C:/Users/Administrator/AppData/Local/Arduino15/packages/esp8266/hardware/esp8266/2.7.4/tools/esptool\esptool.py", line 2336, in write_flash
% (argfile.name, argfile.tell(), address, flash_end))
esptool.FatalError: File C:\Users\ADMINI~1\AppData\Local\Temp\arduino_build_773564/esp8266-data-upload.spiffs.bin (length 1024000) at offset 3145728 will not fit in 1048576 bytes of flash. Use --flash-size argument, or change flashing address.
SPIFFS Upload failed!
|
发表于 2022-5-19 00:49
