感谢楼主谢谢提供这些详细的资料和文字，我的已经完美实现了再次感谢
LEGION811 发表于 2021-11-15 17:07
你好，我想问一下电烙铁的温度怎么校准？谢谢
校准温度是这样的：
1.先准备一个能测温的万用表要有热电偶
2.进入校准界面
3.这时候调节旋钮50-0后面的0调到50等待洛铁温度到50度（误差5），
如果温度高就把数字调小等待温度到达50 ，如果温度低就把数字调大等待温度到达50
然后按下旋钮就确认了最后依次把剩下的温度都校准了（100-150-200-250-300-350-400-450）
avrdude: Version 6.3-20190619
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
Copyright (c) 2007-2014 Joerg Wunsch
System wide configuration file is "C:\Program Files (x86)\Arduino\hardware\tools\avr/etc/avrdude.conf"
Using Port : COM20
Using Programmer : stk500v1
Overriding Baud Rate : 19200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x03
avrdude done.Thank you.
Problem uploading to board.See https://support.arduino.cc/hc/en-us/sections/360003198300 for suggestions.
哪位朋友知道，我的T12刷英文文字版的屏幕可以点亮，刷中文UI版的固件却点不亮屏幕，OLED是白色的，I2C地址是0x3C
楼主提供的这些版本的程序里面，哪个版本是最稳定的呢？我刷的1.7+，自动关机的时候OLED会乱屏